Dishwasher Won’t Start - Top 6 Reasons & Fixes - Whirlpool, GE, LG, Maytag & More

Geat video

Very informative.

My world pool dishwasher when I started the light just flashes and green light flashes doesn’t do anything else

Very helpful

I have a newer GE D/W that has gone blank but will run after the power is turned off for a few minutes and turned back on Thanks Jim

dishwasher cleaned but then it stopped at the end it would not drain and would not come back on. What you are demonstrating can those be my problem? I just didn't know if things like that just go when its still in a cycle

The video mentions a "tech sheet". Where can you obtain this document?

My dishwasher was not starting. Lights were on. Turn off circut breaker for a few second and turned back on. It now works. Reboot the computer first?

Great video! When I went to remove the control panel to test the door switch, I noticed that the panel was a little loose. The plastic female anchors were all broken and therefore not holding the control panel tight. I tested the door switch since I had it opened and that worked. So I put longer screws in to better secure than panel. Running a test load now. So far , it's working. Will let you know if the lights start blinking again and it stops working.

This video saved me a repair bill and/or the cost of replacing our dishwasher. Thanks, not all heroes wear capes!

I have been hesitant to open the front panel because...well,...electronics. Thank you for making it seem so "easy." Any now I'm off to get one of those continuity thingamajigs. Wish me luck!

good video

My portable GE dishwasher won’t start. Several months ago I had the timer replaced. When it wouldn’t start, I checked the basics. Then my husband leaned over the washer to get some coffee and leaned down on the washer and it started. When he stood up, it stopped. I opened the latch compartment and there was a piece of paper in there. I removed it, put everything back together and the washer started. I worked for two loads and then it quit in the middle of the cycle. Now it won’t start at all again. Can something in there be loose? What should I do? Thank you in advance for your videos.

😃

child lock blinking on kitchen aid dishwasher. Tried pushing energy saving button for 5 seconds. Didn't work
and delay hours 2 light blinking,cancel light blinking
I try everything not working

I have an older model GE natilus dishwasher with a timer and metal latch assembly. The problem I'm having is it will run for a few minutes then cut off. When it cuts off I have to unplug the washer and wait about 15 or 20 minutes then it will run again for a few minutes. Any ideas on what my issue could be?

Cyle and start button won't compress

Hello iam a maintenance technician and this info was very useful for me to complete work with some of the appliances that I wasn't too familiar with fixing thank you very much and keep up the good work

Be real . Hold the cancel or drain button down if you don’t have a reset button. Just like restarting a computer, hold the button down for a minute. That’s a restart

Great job thanks

Matt is my hero.

I was able to find the problem in my wife's dishwasher, thank you for the video I appreciate it a lot!

It's bad, dishwashers at all, I had one for Costco, before In 3 years broken down 6 times it's repaired and replacement most of parts but not working probably (water from kitchen sink go inside the dishwasher ) I paid for 3 years extending warranty with Allstate after 2 years manufacturer warranty Allstate refused repair
Don't buy this brand for every body

Hey thanks a lot! Keep these videos coming!

Have a blessed day!

Hai

I have problems in E4F4 can u help

Model # pdt715synofs