Battery Low Voltage Disconnect Board 33621 MI MPJA.com

I planned on writing a sketch to control a low-voltage cutoff circuit for a battery pack. My parts count would have been migher than this unit. Thanks for saving me the time and resources.

Wow video

Hello, and thanks for the video.
does it memorize the set value when you disconnect it?
Or do you have to set it again next time?

Hi can I sense a 72V batterie with it and disconnect it at 55V???

Hi Friend, I am trickle charging my car battery through Dewalt 20V using LM2596 and it's working really good and have been using it for about an year from now. Now my question is I want to protect my Dewalt Battery from going too low on Voltage and I tried using XH-M609 and LM2596 together but it didn't work. Now what do you suggest me to buy which might help. I appreciate any help please.

Thanks for the video, what a great little device. I would be interested in the control of the relay to turn on and off my 24v inverter via the remote switch, not the switching of the power through the device. Are the relay pins accessible through the bottom of the PCB?

I Have 2, 18 Volt Milwaukee Batteries Wired in Series? They Have a On board Cutoff that Only Works With The Milwaukee Power Tools?
I Have This System for my Son's Power Wheel what's the Cutoff Voltage for That 36 Volts
33 Volts for the Series set up? Or
16.5 Volts For the Capacity of Each 18 Volt Battery?
If you Have Any Suggestions? It would Be Greatly appreciated 👍

Sir please share the circuit diagram for LVD(LOW VOLTAGE DISCONNECT)
1.connects the when the voltage >48vdc(load 100 amps)
2.disconnects the circuit when the voltage <42v dc (

When relay is off, how mucha Amps need it?

I use a similar board for my 20v dewalt battery ammo Bluetooth speaker builds if I don’t use this board and the voltage drops below 17vdc the battery will not charge on the charger u can jump it but can cause damage this board keeps it from going too low

I have the XH-M609 great little item, I used one in my car and one hooked up with my Solar power lights i hooked up in the barn.
If you press both buttons together wait for the LCD to stop flashing this will set back to the Factory setting.

Why wouldn't you solder in a switch for the display to reduce consumption?

Nice demonstration.