Make a center finder

Thanks Koubou ...

Nice! You could also attach a hardened steel tip to scratch the center line.

Muito bom parabéns!

It would have been nice to have a center finder when making the center finder. Beautiful work as always!

PERFECTO COMO SIEMPRE,SALUDOS.

Simple and perfect.

очень долго показываешь мелочь.

精度が高いので、落ち着いて観ています。素晴らしいですね！

🖒🖒🙌🙌

Да, классная штука!

hello. thanks for video! where can I see the making of vertical saw statement ?

А зачем карандаш вклеивать, а потом вынимать?

very basic do that, but...

100% perfect..............and easy

Very good.

You, my friend, are a genius!

Fantastic work, dude! Really well done! 😃

Very good 👍

センターファインダーを作るためにセンターをファイン度しなければならない矛盾

Toujours aussi agréable
De vous voir faire
Merci de partager vos astuces

Do you notice that when you turn on, and especially when you turn off the drill, does the speed increase? This is because the drill is not working at its nominal power. You should actuate the trigger with a seal at its maximum travel and place an extra switch on the machine frame. Even the perforations are going out more accurate. Greetings from Argentina!

👏👏👏👍👍👍

You strike me as the guy that can complete most tasks but do so in a painfully slow manner

So simple, efficient, cheap, but not from a simple of mind ;-) and what amazing press set (by yourself indeed)

Thanks verry nice

日本 のclip みたいです

Ты когда ногти будешь стричь?

why the glue on the pencil?

Very Good!

Старо как Мир...

You are genius! Good work!

I found one of these - but with the pencil missing - in a handful of small woodworking bits I inherited many years ago. I asked a few people what it was but no-one knew. Now I shall have to make one for myself! (The one I inherited also had a little round spirit bubble in the top.) Domo arigato!

but can it be used to find the centre of the universe?

👍

Mind blown. That trick to get the outside holes to be equally spaced from the center was genius. Thanks.

I find that when you turn the centre finder round the other way the lines don’t line up...

Bravo Bravo ..

Who was the original inventor? Unable to find the info. I know that this was invented by someone long ago

Good job bro

One problem: The center line that is placed before punching a guide hole, must be exact, otherwise the block will not line up when turning it. Now what?

sensacional!!!🤌👏👍

Simple but not easy. It’s needed accurate tools and good skills. Good job!

Actually you induce error by turning the peace for 180 degree, if first center punch is not in the middle precisely! What you should do is drill first hole through work peace and bottom helping peace, than move both by some offset and with pin connecting them, than drill second hole on work peace, than offset only work peace and align it with pin...

Bitte alle Maße im Video einblenden um es leichter nachbauen zu können! Danke!

go next step. Drill second hole between center and stop or one quarter to three quarters stop to stop to 'quarter' a board. drill a third hole in the other half at one third stop to stop to 'third' a board.

If you find any unauthorized reproduction of the JSK-koubou video, please report it to me.
Thank you.
JSK-koubouビデオの無断複製を見つけた場合は、報告していただけると助かります。