How to fit the Van-X T5, T5.1 Cup Holder Replacement [Fitting Tutorial]

There’s 3 wires where does the third one go

A thousand attempts to get that spring cap back in.

That’s not the way to do it. Never cut your loom. There’s a plug.

I just watched a vid where a welsh fella dismantled half his vehicle to take that out

What colour wire do you not connect back up again?

Absolute bodge! Expected terrible advice from a manufacturer that produces cheap tat.

Not as smooth as the factory cup holder.. in fact don’t attempt to pull it out unless you workout 😂 going to strip it out again tomorrow and hopefully find the cause

Thank you so much for this video. I was having no end of trouble getting my old one out. All sorted now though thanks to you. Cheers.

Just fitted mine after buying from 'The Caravan, Camping and Motorhome Show' today. All went ok but seems very tight when pushing closed on the final inch and when pulling open at the beginning as well. Hopefully will loosen up.

Where can I get s replacement spring and wheel thingy?